|
1AESS Common Input Msgs FM03 Error rate of specified digroup FM04 Digroup out of frame more than indicated FM05 Operation or release of the loop terminal relay FM06 Result of digroup circuit diagnostics FM07 Carrier group alarm status of specific group FM08 Carrier group alarm count for digroup FM09 Hourly report of carrier group alarms FM10 Public switched digital capacity failure FM11 PUC counts of carrier group errors ** MAINTENANCE ** MA02 Status requested, print out of MACII scratch pad MA03 Hourly report of system circuits and units in trouble MA04 Reports condition of system MA05 Maintenance interrupt count for last hour MA06 Scanners,network and signal distributors in trouble MA07 Successful switch of duplicated unit (program store etc.) MA08 Excessive error rate of named unit MA09 Power should not be removed from named unit MA10 OK to remove paper MA11 Power manually removed from unit MA12 Power restored to unit MA13 Indicates central control active MA15 Hourly report of # of times interrupt recovery program acted MA17 Centrex data link power removed MA21 Reports action taken on MAC-REX command MA23 4 minute report, emergency action phase triggers are inhibited ** MEMORY ** MN02 List of circuits in trouble in memory ** NETWORK TROUBLE ** NT01 Network frame unable to switch off line after fault detection NT02 Network path trouble Trunk to Line NT03 Network path trouble Line to Line NT04 Network path trouble Trunk to Trunk NT06 Hourly report of network frames made busy NT10 Network path failed to restore ** OPERATING SYSTEM STATUS ** OP:APS-0 OP:APSTATUS OP:CHAN OP:CISRC Source of critical alarm, automatic every 15 minutes OP:CSSTATUS Call store status OP:DUSTATUS Data unit status OP:ERAPDATA Error analysis database output OP:INHINT Hourly report of inhibited devices OP:LIBSTAT List of active library programs OP:OOSUNITS Units out of service OP:PSSTATUS Program store status ** PLANT MEASUREMENTS ** PM01 Daily report PM02 Monthly report PM03 Response to a request for a specific section of report PM04 Daily summary of IC/IEC irregularities ** REPORT ** REPT:ADS FUNCTION Reports that a ADS function is about to occur REPT:ADS FUNCTION DUPLEX FAILED No ADS assigned REPT:ADS FUNCTION SIMPLEX Only one tape drive is assigned REPT:ADS FUNCTION STATE CHANGE Change in state of ADS REPT:ADS PROCEDURAL ERROR You fucked up REPT:LINE TRBL Too many permanent off hooks, may indicate bad cable REPT:PROG CONT OFF-NORMAL System programs that are off or on REPT:RC CENSUS Hourly report on recent changes REPT:RC SOURCE Recent change system status (RCS=1 means RC Channel inhibited) ** RECENT CHANGE ** RC18 RC message response ** REMOVE ** RMV Removed from service ** RESTORE ** RST Restored to service status ** RINGING AND TONE PLANT ** RT04 Status of monitors ** SOFTWARE AUDIT ** SA01 Call store memory audit results SA03 Call store memory audit results ** SIGNAL IRREGULARITY ** SIG IRR Blue box detection SIG IRR INHIBITED Detector off SIG IRR TRAF Half hour report of traffic data ** TRAFFIC CONDITION ** TC15 Reports overall traffic condition TL02 Reason test position test was denied TL03 Same as above ** TRUNK NETWORK ** TN01 Trunk diagnostic found trouble TN02 Dial tone delay alarm failure TN04 Trunk diag request from test panel TN05 Trunk test procedural report or denials TN06 Trunk state change TN07 Response to a trunk type and status request TN08 Failed incoming or outgoing call TN09 Network relay failures TN10 Response to TRK-LIST input, usually a request from test position TN11 Hourly, status of trunk undergoing tests TN16 Daily summary of precut trunk groups ** TRAFFIC OVERLOAD CONDITION ** TOC01 Serious traffic condition TOC02 Reports status of less serious overload conditions ** TRANSLATION ** (shows class of service, calling features etc.) TR01 Translation information, response to VFY-DN TR03 Translation information, response to VFY-LEN TR75 Translation information, response to VF:DNSVY ** ** TW02 Dump of octal contents of memory X-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-X