Legal Info:
Tampering with phone boxes is illegal, if you are apprehend for tampering
means if convicted, jail or heavy fines. If done across state lines it is
considered a federal offense.

NOTE:This document was intended for informational purposes ONLY, the author
does not endorse or support any illegal action presented here; the only
motivation for writing of this document is purely for educating the general
public. Any actions by the readers of these plans will not be held responsible
against the author.

Function:
When applied to targets phone box, targets phone will emit
massive amounts of static over the phoneline, making it very
difficult to understand a call and making communications almost
impossible. The Tone Box will go long periods of time undetected
due to most residents lack of technical knowledge about phone systems.

Building/Installing A Tone-Box:
Materials:
1 5k Potentiometer/10k Potentiometer 15 turn
1 1.0-1.5 uf Capacitor, non-polarized, 100vdc+
1 100 ohm, 1/2 or 1/4 watt resistor
2 Alligator clips
1 Beige box
1 Green base (closest to victim's house)

Procedure:
1) Solder one end of the capacitor to the middle lug of the pot.
2) Solder one end of the resistor to either remaining end on the pot.
3) Attach alligator clips on the other ends of the capacitor and resistor.
4) Go to the green base by the victim's house.
5) Open the green base to expose the terminal block.
6) With a beige box, locate the victim's line using ANI.
7) Remove the beige box and remember which terminal it was.
8) Take your noise box and hook the capacitor's clip on the tip of the
victim's terminal. (tip - left side)
9) Hook the resistor's clip on the ring of the victim's terminal.
(ring - right side)
10) Put the beige box back onto the terminal and press a digit. Listen
for any noise, and slowly adjust the pot until you hear the greatest
amount of line-noise. Stop adjusting the pot, remove the beige box,
and close the green base.

The Tone Box should be installed.